Effects of dynamic parameters on measurements of IV curve

Conference proceedings article


ผู้เขียน/บรรณาธิการ


กลุ่มสาขาการวิจัยเชิงกลยุทธ์

ไม่พบข้อมูลที่เกี่ยวข้อง


รายละเอียดสำหรับงานพิมพ์

รายชื่อผู้แต่งSeapan M., Limsakul C., Chayavanich T., Kirtikara K., Chayavanich N., Chenvidhya D.

ปีที่เผยแพร่ (ค.ศ.)2008

ISBN9781424416417

นอก0160-8371

eISSN0160-8371

URLhttps://www.scopus.com/inward/record.uri?eid=2-s2.0-84879706389&doi=10.1109%2fPVSC.2008.4922589&partnerID=40&md5=4d505bff41c699548406a5c9ba784a7b

ภาษาEnglish-Great Britain (EN-GB)


ดูบนเว็บไซต์ของสำนักพิมพ์


บทคัดย่อ

In current-voltage characteristic measurements of a PV module, distortions of curves can often be observed when measurements are done under flash tester with different sweeping rates of curve tracing, direction of tracing from short circuit to open circuit (SCOC)or from open circuit to short circuit (OCSC). In our recent work, we observed that dissimilarities of IV curves of a PV module, maximum power and fill factor, can be explained in terms of charging or discharging capacitive current due to voltage dependence of solar cells. This paper describes that measured maximum powers of a PV module are deviated around 2% when measurements are done with varying sweeping rates from 2 ms to 10 ms and directions of tracing of SCOC and OCSC conditions. The results are comparable with time constants of a module obtained by using dynamic characterization. Our methods using square wave inputting signal, both in the dark and in the illumination conditions, can determine not only time constants, but also determine dynamic parameters of a module. We found that the overestimation or underestimation of output powers are obtained when the sweeping rates are not more than time constants, and each time constant is depend on each operating voltage. ฉ 2008 IEEE.


คำสำคัญ

ไม่พบข้อมูลที่เกี่ยวข้อง


อัพเดทล่าสุด 2023-04-10 ถึง 07:35