Effect of membrane module arrangement of gas-liquid membrane contacting process on CO2 absorption performance: A modeling study

บทความในวารสาร

ผู้เขียน/บรรณาธิการ

กลุ่มสาขาการวิจัยเชิงกลยุทธ์

ไม่พบข้อมูลที่เกี่ยวข้อง

รายละเอียดสำหรับงานพิมพ์

รายชื่อผู้แต่ง: Boributh S., Assabumrungrat S., Laosiripojana N., Jiraratananon R.

ผู้เผยแพร่: Elsevier

ปีที่เผยแพร่ (ค.ศ.): 2011

วารสาร: Journal of Membrane Science (0376-7388)

Volume number: 372

Issue number: #

หน้าแรก: 75

หน้าสุดท้าย: 86

จำนวนหน้า: 12

นอก: 0376-7388

eISSN: 1873-3123

URL: https://www.scopus.com/inward/record.uri?eid=2-s2.0-79953030071&doi=10.1016%2fj.memsci.2011.01.034&partnerID=40&md5=fb2022fb6204b9104890a70a20223891

ภาษา: English-Great Britain (EN-GB)

ดูในเว็บของวิทยาศาสตร์ | ดูบนเว็บไซต์ของสำนักพิมพ์ | บทความในเว็บของวิทยาศาสตร์

บทคัดย่อ

Mathematical models have been developed to analyze and predict the physical absorption performance of CO2 through hollow fiber membrane contactors with different membrane module arrangements. The membrane contactor module is operated under partially wetted and counter-current flow mode. Four membrane module arrangements including single-stage module (SM), in parallel two-stage module (IP-TM), in series two-stage module with separated liquid flow (IS-TMS) and in series two-stage module with combined liquid flow (IS-TMC) are considered. The difference in module arrangement results in different degree of membrane wetting and concentration profiles along the module. The simulation is performed at the liquid flow rates in a range of 5.67-15.75m3/s. At low liquid flow rate (up to 7.5×10-5m3/s) at which the penetration of liquid into membrane pores is less than 7.6%, the total resistance is dominated by liquid phase. The absorption performance shown in term of contact area can be ranked as SM>IS-TMC>IP-TM>IS-TMS. For high liquid flow rate, the gas phase resistance becomes comparable to the liquid phase resistance. The IS-TMS shows highest absorption performance followed by IP-TM, IS-TMC and SM, respectively. The effects of important design parameters including gas composition (CO2-CH4), split ratio of liquid (α), the fraction of CO2 removal at the middle and exit of stage (xM, xexit), liquid temperature and number of stage on required contact area are also investigated. © 2011 Elsevier B.V.

คำสำคัญ

Physical absorption