Single-stage electronic ballast using class-DE low-dv/dt current-source-driven rectifier for power-factor correction

บทความในวารสาร


ผู้เขียน/บรรณาธิการ


กลุ่มสาขาการวิจัยเชิงกลยุทธ์

ไม่พบข้อมูลที่เกี่ยวข้อง


รายละเอียดสำหรับงานพิมพ์

รายชื่อผู้แต่งEkkaravarodome C., Nathakaranakule A., Boonyaroonate I.

ผู้เผยแพร่Institute of Electrical and Electronics Engineers

ปีที่เผยแพร่ (ค.ศ.)2010

วารสารIEEE Transactions on Industrial Electronics (0278-0046)

Volume number57

Issue number10

หน้าแรก3405

หน้าสุดท้าย3414

จำนวนหน้า10

นอก0278-0046

eISSN1557-9948

URLhttps://www.scopus.com/inward/record.uri?eid=2-s2.0-77956587977&doi=10.1109%2fTIE.2009.2039453&partnerID=40&md5=87539b137c29a2eb6dff4c4c41cea7d1

ภาษาEnglish-Great Britain (EN-GB)


ดูในเว็บของวิทยาศาสตร์ | ดูบนเว็บไซต์ของสำนักพิมพ์ | บทความในเว็บของวิทยาศาสตร์


บทคัดย่อ

A single-stage high-power-factor electronic ballast with a Class-DE low- dv/dt rectifier as a power-factor corrector is proposed in this paper. The power-factor corrector is achieved by using a bridge rectifier that acts as the Class-DE low-dv/dt rectifier. The Class-DE low-dv/dt rectifier is driven by a high-frequency current source, which is obtained from the square-wave output voltage of the Class-D parallel resonant inverter through an LC-series circuit. By using this topology, the conduction angle of the bridge rectifier diode current is increased, and a low line-current harmonic is obtained. A prototype ballast is implemented to drive a 36-W fluorescent lamp. The switching frequency is fixed at about 84 kHz. Experimental results verify the theoretical analysis. The designed electronic ballast has a power factor of 0.99, a total harmonic distortion of 1.3%, a lamp current crest factor of 1.42, and 90% efficiency at full power. ฉ 2010 IEEE.


คำสำคัญ

Class-DE low-dv/dt rectifierclass-D parallel resonant inverterpower-factor correction (PFC)single stage


อัพเดทล่าสุด 2023-23-09 ถึง 07:35