Computational Analysis and Experimental Investigation of Optical Efficiency of Concentrating Photovoltaics equipped with a Secondary Optic Element

Conference proceedings article


ผู้เขียน/บรรณาธิการ


กลุ่มสาขาการวิจัยเชิงกลยุทธ์

ไม่พบข้อมูลที่เกี่ยวข้อง


รายละเอียดสำหรับงานพิมพ์

รายชื่อผู้แต่งPatanasemakul N., Rakkwamsuk P., Chuangchote S., Songprakorp R., Kirtikara K.

ผู้เผยแพร่Elsevier

ปีที่เผยแพร่ (ค.ศ.)2017

Volume number138

หน้าแรก604

หน้าสุดท้าย609

จำนวนหน้า6

นอก1876-6102

eISSN1876-6102

URLhttps://www.scopus.com/inward/record.uri?eid=2-s2.0-85035230300&doi=10.1016%2fj.egypro.2017.10.168&partnerID=40&md5=5e10a8fef6241fac0af15b6ece5fcc74

ภาษาEnglish-Great Britain (EN-GB)


ดูในเว็บของวิทยาศาสตร์ | ดูบนเว็บไซต์ของสำนักพิมพ์ | บทความในเว็บของวิทยาศาสตร์


บทคัดย่อ

A concentrating photovoltaic system offers high efficiency but limited by its low acceptance angle. This paper presents a method to increase an acceptance angle of a Fresnel lens system by adding a flat plate reflector as a secondary optic element (SOE) at the edge of a receiver. Two-dimension (2D) ray tracing simulations using MATLAB and the optical characteristics of the flat plate reflector are explained. The simulations of a system using Fresnel lens with 14.5 cm diameter and 19 cm focal length were made by varying the SOE plate slope from 50 to 80ฐ. The acceptance angle can be increased from 0.5ฐ of a system without the SOE to 1ฐ by using one with 65ฐ plate slope and 4 cm height and the optical efficiency was still over 50% at 1.9ฐ incident angle. The experimental results showed that improvement of an acceptance angle could significantly increase power gain of a CPV system operating under tropical skies in Thailand by 10-20%. In addition, placing a receiver at an off-focal point could improve radiation uniformity and PV's fill factor. ฉ 2017 The Authors. Published by Elsevier Ltd.


คำสำคัญ

Concentrating systemsFresnel lensSecondary optic


อัพเดทล่าสุด 2023-06-10 ถึง 07:36