Comparison of Ortho-planar Spring design optimization based on Linear Elastic and Hyper Elastic Materials

Conference proceedings article

ผู้เขียน/บรรณาธิการ

กลุ่มสาขาการวิจัยเชิงกลยุทธ์

ไม่พบข้อมูลที่เกี่ยวข้อง

รายละเอียดสำหรับงานพิมพ์

รายชื่อผู้แต่ง: Graipaspong R., Chanthasopeephan T.

ผู้เผยแพร่: EDP Sciences

ปีที่เผยแพร่ (ค.ศ.): 2018

Volume number: 166

นอก: 2261-236X

eISSN: 2261-236X

URL: https://www.scopus.com/inward/record.uri?eid=2-s2.0-85046760879&doi=10.1051%2fmatecconf%2f201816601004&partnerID=40&md5=72588e60dc808861209e3504d2d79cbd

ภาษา: English-Great Britain (EN-GB)

ดูในเว็บของวิทยาศาสตร์ | ดูบนเว็บไซต์ของสำนักพิมพ์ | บทความในเว็บของวิทยาศาสตร์

บทคัดย่อ

In this paper, compliant Ortho-planar spring was designed based on a three-dimensional topology optimization method. The computation was developed using MATLAB programming. The objective of this work was to apply dual method to design an Ortho-planar spring while the design should have minimum mass and at the same time satisfy a set of constrained displacement. Throughout this paper, we analyzed a method for designing an Ortho-planar spring using linear elastic material and hyperelastic material. The results showed that under small displacement conditions, the output displacement, maximum stress magnitude, and the maximum stress of linear elastic assumption and hyper-elastic material were relatively close to each other. However, the mass fraction and the layout as the result of the optimization process was different. As for larger displacement, the maximum stress of linear elastic material appeared 2.59 times higher than the maximum stress of the hyper-elastic material model. The topology optimization output based on linear material was invalid because the topology of the computed Ortho-planar spring was not appeared as a one-piece layout while the design based on nonlinear material looked promising. ฉ 2018 The Authors.

คำสำคัญ

ไม่พบข้อมูลที่เกี่ยวข้อง